Easy to install

Included: thin circuit board & Keypad

Item#FKR3585

Factory Direct Price: $15.00

 Remove the front and back Nokia 3585 3585i 3586i 3588i 3589i 3570 cell phone plates, keypad and battery.

Insert the two metal contacts on the end of the circuit sheet into the left-most and right-most battery contacts. The metal contacts should be inserted so that the thin strip runs down along the center inside of the battery compartment. About half way down the battery, the thin strip makes a turn so that it would wrap around the side of the naked phone and end up on the front side.

Carefully bend the thin strip so that is conforms to the side of the phone and place the flashing circuit sheet where the keypad goes on the front side of the naked phone. You may wish to use small pieces of adhesive tape to the thin strip of the circuit sheet stay in place, if necessary.

Place the keypad onto the circuit sheet making sure the pegs under each key goes through the holes in circuit sheet and into the respective holes on the phone. Keypad will help hold the circuit sheet in place.

Replace the battery and the lights should immediately start flashing. If the keypad does not light up immediately, you may need to adjust the contacts at the battery contacts. Replace the front and back plates. Be sure to adjust all individual keys so that each key can be pressed properly.